Glossary entry (derived from question below)
English term or phrase:
cullar and chucking face
Polish translation:
tuleja zaciskowa i powierzchnia uchwytowa
Added to glossary by
Frank Szmulowicz, Ph. D.
May 16, 2020 15:03
4 yrs ago
7 viewers *
English term
cullar and chucking face
Non-PRO
English to Polish
Tech/Engineering
Metrology
cullar and chucking face (hobs)
Jednozdaniowy opis testu frezu ślimakowego
Radial/axial run-out upper; lower test cullar and chucking face - tak brzmi pełne zdanie
Z góry dziękuję za pomoc.
Radial/axial run-out upper; lower test cullar and chucking face - tak brzmi pełne zdanie
Z góry dziękuję za pomoc.
Proposed translations
(Polish)
2 | tuleja zaciskowa i powierzchnia uchwytowa | Frank Szmulowicz, Ph. D. |
Change log
May 21, 2020 10:47: Frank Szmulowicz, Ph. D. Created KOG entry
Proposed translations
22 hrs
English term (edited):
collet and chucking face
Selected
tuleja zaciskowa i powierzchnia uchwytowa
chucking odnosi się do mocowania
4 KudoZ points awarded for this answer.
Discussion
Axial run-out is the result of a rotating component not being parallel with the axis, such as a drill chuck not holding the drill exactly in line with the axis. In general, cutting tools are less tolerant of axial run-out since the tool tip tends to dig in and further increase run-out. However, a shaft may be more tolerant of axial run-out since the centre of gravity is displaced less.
- https://en.wikipedia.org/wiki/Run-out
A chuck adapter (Figure 8-17) is used to attach chucks to milling machines having a standard spindle end. The collet holder is sometimes referred to as a collet chuck. Various forms of chucks can be fitted to milling machines spindles for holding drills, reamers, and small cutters for special operations. - http://uhv.cheme.cmu.edu/procedures/machining/ch8.pdf - page 11